SHADES INSTRUCTIONS

Instruction PDF download

1. Drill a 3/8" hole at the wire location at the top or side of the header/framing

2. Drill a 1" wide by 2" deep hole for the Groove inside the frame

3. Trim the wire to length, allowing for 8 inches of slack wire

4. Run the wire down through the 3/8" hole

5. Attach the wire to the Groove by pulling wire through the top cap loop and secure the wire together

6. Push the Groove up into the hole, to be buried until Trim

1. Remove one of the four "break away openings to feed the wire into the Slackbox Bubble. The fit should be tight to keep out spray form.

2. Secure the Bubble with two screws to the top or side of your header, placing the slack end directly over the wire hole.

3. Push up to 8" of slack wire into the Bubble.

1. Scan the finished surface with the blue side of the Quantum Xcentric tool.

2. Flip the Quantum over, the red side will snap to the Groove.

3. Make a mark at each notch around the sides of the Quantum.

4. Remove the Quantum and drill a 1 inch hole in the center of the marks.

Notch

with insert

XPOE with cap

XSnap

with cap

XGrommet

Cable Routing and Termination
- Route the cable through the Xgrommet. For pre-terminated cables, utilize either the Notch or XSnap entry point and trim around the shade motor as required.
- For RJ45 terminations, remove the retention clip from the RJ45 connector and snap the insert into the lower port of the XPOE.
- Secure the grommet using the integrated screw mount, available on both the XPOE and XSnap models.
Flange Adjustment (optional)
- The outer flange of the Xspot grommet can be removed to achieve a flush-mount installation.
Cable Management and Covering
- Feed any excess cable back into the cavity and Slackbox Bubble.
- Install the shade bracket over the grommet to complete the assembly.